Latexplan 2Part Floor Leveller is a levelling and smoothing compound, protein-free with low odour and high compressive strength. For leveling or smoothing differences in thickness of 1-10mm to receive all types of floor coverings. Slower hardening making it suitable for rubbing down. For interior use only. Suitable for underfloor heating. Suitable for use under MAPEPROOF 1K TURBO, MAPEPROOF ESM & MAPEPROOF ONE COAT surface membranes.

Key Features:>

• Coverage: Approx 6m² at 3mm thickness
• Can be rubbed down
• Protein free
• Low odour
• Can be used with underfloor heating
• High compressive strength

Surface Preparation
The subfloor must be clean structurally sound free from grease oil paint and plaster residues surface laitance and contamination including surface hardeners and additives that may compromise the bond. On highly porous and absorbent substrates, a coat of primer prior to application will prevent pinholes / air bubbles within the surface, providing a smooth even finish.

Recommended Systems
Mix 25kg of Latexplan Trade Part A powder into 5 litres of Latexplan Trade Part B liquid. The Latexplan Trade Part B liquid container should be shaken, poured into a clean mixing container and the Latexplan A powder added gradually whilst continually stirring with a mixing paddle and slow speed drill. The mix has a working time of approx. 20-30 minutes at +23°C. Do not add more latex or water to the mix once it has begun to set. The mixed material is poured onto the prepared subfloor and spread with a smooth edged trowel to the required thickness in one operation. Alternatively the use of a spiked roller will ensure a smooth even finish that will require no further attention prior to the installation of floor coverings. The correct mix permits any application from feather finish to 10mm, although for best results a minimum 3mm application is recommended. Apply at a floor temperature above +5°C.

Technical Characteristics
Latexplan Trade is a two part smoothing compound that consists of a grey powder (part A) containing special cements graded silica sands and additives to be mixed with a synthetic rubber latex (part B) latexplan trade can be walked on after approximately 1½ - 2 hours and is ready for installing flooring after about 12 hours depending on the thickness and the ambient temperature Latexplan Trade has a very low odour making it suitable for use in confined and inhabited areas where working and /or occupation must be maintained suitable for use under Mapeproof ESM surface membrane where residual or static moisture is present for the best results Latexplan Trade should be mixed without extra latex or water being added.