Show Prices Including VAT

We're here to help 020 8362 8100

  • Take a tuor through our store in New Southgate
  • Branch Finder
  • Find out about our delivery service
  • Dispaly Prices excl. VAT

Cementone Resin For Blocks Matt Satin Sealer & Sand Binder 5L

Status : In stock

Delivery : Standard help

SKU : L015204
Inc VAT: £57.36
OR

For assistance, please call:

020 8362 8100

Cementone Resin For Blocks Matt Satin Sealer & Sand Binder 5L
Move your mouse over image or click to enlarge
Cementone Resin for Blocks-Matt Satin Finish is a polyurethane sand binder and sealer for use on concrete block paving. Resin for Blocks impregnates the blocks and the jointing sand. When dry, the sand and the blocks are permanently bonded together to ensure the sand is not washed out of the joints and the paving is sealed from weed growth, efflorescence and stains.

Key features
  • For sealing concrete & clay block paving on well drained drives, paths and patios
  • Permanently bonds sand and the blocks
  • Prevent weed growth

Preparation
For existing drives, Paving must be clean and free of dust, weeds, algae, stains and efflorescence. Jet washing is recommended this may remove some of the jointing sand which must be replaced on the day the sealer is applied. Replace or clean any badly stained blocks and treat efflorescence with Cementone Brick & Patio Cleaner. Allow 2 weeks after cleaning to ensure efflorescence does not re-appear. For new drives Ensure the drive is clean and free of dust and any surface weakness such as efflorescence. For best results clean the blocks with Cementone Brick & Patio Cleaner to remove efflorescence; then wash down thoroughly with clean water. Allow 8 weeks after cleaning to ensure efflorescence does not re-appear. On the day of sealing, ensure the paving is thoroughly dry (no rain for 48 hours). Brush fresh kiln dried sand into the joints with a soft broom. Before applying the sealer, ensure there is no sand on the face or on the bevelled edges of the blocks. Protect adjacent surfaces, ponds and plants from splashing.

Application
Cementone Resin For Blocks-Wet Look Finish should only be applied when the temperature is between 5 and 30 degrees. Wear protective gloves, clothing and goggles. Two coat system for maximum protection and enhanced appearance. First coat perimeter of area to be sealed up to the first joint line with a 10 cm (4'') paint brush. Coat the blocks using a short pile roller and work diagonally across the joints from side to side. Apply at a rate of 3 m2/litre to ensure good penetration. Do not press too heavily on the roller and do not allow the sealer to pool. If it is necessary to take a break, always stop along a joint line to avoid striping. Apply second coat after 3-4 hours, preferably on the same day but no longer than 24 hours. Work at right angles to the first coat and apply an even coat at 6 m2/litre. Leave sealed area to dry. This is usually about 2-6 hours for foot traffic and 24-48 hours for vehicles. However, if the temperature falls below 10 degrees (e.g. overnight) the drying time will be extended. It is recommended that you ensure the surface has dried fully and is not tacky before allowing vehicular traffic.
Weight 4.87kg
Unit Of Sale Each
Size 5L
Barcode 5010591367135
EDP code 367135
Brand Cementone

You must be logged in to post a question.

No comments just yet - be the first!

Product Reviews

Number of reviews : 1
Average rating : 3 /5
H. David
  the 23/08/2016
3/ 5
its a good product but solidifies quite quickly

There are no products matching the selection.

There are no products matching the selection.

Post your comment

Builder Depot